Metrohm tiamo 1.3 Manual - Manual (Page 140)

114 Workplace
Modification comment for sample data
If the option Comments on modification of sample data is switched on in the Security
settings then before the edited sample data is accepted the window Modification
comment sample data opens first, in which a reason for the modification must be
selected and comments about the modification must be entered.
Reason
Selection from standard texts
Slection from the Default reasons defined in the dialog window Security set-
tings for the category Modification of sample data .
Comment
1000 characters
Entry of comments about the modification to the sample data.
Determination run
A determination that is started on the tab Single determination in the subwindow
Run takes place as follows:
1 - Load sample data
The Sample data entered on the tab Single determination is loaded for the deter-
mination.
2 - Select method
Method selection triggers the following actions:
• Select method without assignment ID
If the option
Method selection by assignment ID is not switched on on the tab
Process then the method selected in the field Method will remain loaded.
• Select method with assignment-ID
If the option
Method selection by assignment ID is switched on on the tab
Process then the Sample assignment ID will be used to load the method de-
fined in the Sample assignment table .
3 - Carry out start test
During the Start test the following checks and actions are triggered:
• Right to carry out the method?
Checks whether the logged-in user has the right to execute the particular
method.
• Method executable?
Checks whether the particular method is executable. If the method is non-
executable then a message appears asking for the Method test to be car-
ried out and the method edited accordingly.
• Check device (module) and rack
Checks whether the devices (or device types), modules (e.g. measuring in-
puts, towers, etc.) and racks demanded in the device-specific commands
are present and available or assigned. If the device has not yet been as-