Metrohm tiamo 1.3 Manual - Manual (Page 49)

Formula editor 23
Identifier Description Commands
.ENP Electrode zero point of the sensor used for the command (di-
mensionless for pH sensor or in mV for ISE sensor) or the elec-
trode zero point calculated from the calibration (for CAL LOOP)
DET pH, DET U,
MET pH, MET U,
SET pH, SET U,
STAT, MEAS pH,
MEAS U, MEAS T,
MEAS Conc,
STDADD, CAL
LOOP, DOS
.EP{#}.DME Difference in measured values for end point # (1...9) MET
.EP.DVT Drift for end point in µg/min KFC
.EP{#}.ERC ERC for the end point # (1...9) DET
.EP{#}.MEA Measured value for the end point # (1...9) in the units of the
measured value DET, MET, SET,
KFT, KFC
.EP{#}.MEP Number of end points in the window # (1...9); 1 = 1 end
point, 2 = 2 or more end points, 3 = EP corrected with
auto drift, 4 = EP corrected with manual drift DET, MET, SET,
KFT
.EP.QTY Measured value (water) for end point in µg KFC
.EP{#}.TEM Temperature for end point # (1...9) in °C DET, MET. SET,
KFT
.EP{#}.TIM Time for reaching end point # (1...9) in s DET, MET, SET,
KFT, KFC
.EP{#}.VOL Volume for end point # (1...9) in mL DET, MET, SET,
KFT
.ETE Final temperature (temperature after processing the com-
mand) in °C DET, MET, SET,
KFT, KFC, STAT,
MEAS (without
T/Flow), CAL
MEAS, STDADD,
DOS
.EVT Final volume (total volume added at the end of the command)
in mL
DET, MET, SET,
KFT, STAT, DOS
.FIN Command status; 1 = command has been finished at least
once, 0, invalid (variable not present) = command has
never been finished All except START
and END
.FP{#}.DME Difference in measured values for fixed end point # (1...9) MET
.FP{#}.DVT Drift for fixed end point # (1...9) in µg/min KFC
.FP{#}.ERC ERC for fixed end point # (1...9) DET
.FP{#}.MEA Measured value for fixed end point # (1...9) in mV DET, MET, SET,
KFT, STAT
.FP{#}.MEA Measured value for fixed end point # (1...9) in the units of the
measured value KFC, MEAS (with-
out T/Flow)
.FP{#}.QTY Measured value (water) for fixed end point # (1...9) in µg KFC
.FP{#}.TEM Temperature for fixed end point # (1...9) in °C DET, MET, SET,
KFT, STAT, MEAS
(without T/Flow)