Metrohm tiamo 1.3 Manual - Manual (Page 410)

384 Method
General/Hardware
Screenshot and parameters: see DET pH - General/Hardware
Start conditions
Screenshot and parameters: see DET pH - Start conditions
Titration parameters
Parameters defining the run of the titration.
Command name
25 characters, [ MET pH # ]
Name of the command.
Titration rate
Titration rate
Three predefined sets of parameters can be selected for the titration rate:
slow , optimal and fast . For these sets the parameters for the Measured value
acceptance and Dosing of increments are not displayed. In order to edit these
parameters the value user must be selected.
slow
For titrations in which the finest details are also to be visible. However, this
can also increase noise and lead to the production of unwanted EPs.
[ optimal ]
Parameter set for all standard titrations; optimized for the most frequent
applications.
fast
For less critical rapid titrations.
user
Editing the individual titration parameters which affect the titration rate.
Measured value acceptance
(only visible for Titration rate = user )