Metrohm tiamo 1.3 Manual - Manual (Page 275)

Subwindow Determination overview 249
Note
If new end points are set manually or by intersection or tangent evalua-
tion or if existing end points are deleted then the end points will always
be renumbered from left to right. In principle during recalculation the
automatic evaluations will no longer be used for curves, i.e. the end
points defined in the curve evaluation are retained.
Set horizontal auxiliary lines
By moving the mouse a horizontal auxiliary line is drawn in the graph;
this can be set by clicking with the left-hand mouse key. This function is
only active when the option Show evaluation lines is switched on.
Set vertical auxiliary lines
By moving the mouse a vertical auxiliary line is drawn in the graph; this
can be set by clicking with the left-hand mouse key. This function is
only active when the option
Show evaluation lines is switched on.
Delete endpoints and auxiliary lines
With the context-sensitive menu item EP# the selected end point can
be deleted, with ###.### the selected auxiliary line can be deleted.
Zoom
By drawing out a rectangle with the left-hand mouse key the selected
area can be zoomed.
Reset zoom
The graph will be reset to the zoom step 100%.
Copy to clipboard
The contents of the curve window is copied to the clipboard.
Define properties for graph display
The Properties window opens for the curve display. The curve proper-
ties defined for each command type are saved for the reprocessing
window per client.
Show EP list
Opens the dialog window End points in which all the end points of the
selected curve are shown in a table. If an end point is added to or de-
leted from the curve then the table will be updated automatically.
Show coordinates
The current coordinates of the cursor are shown in the coordinate display:
X:
X-coordinate.
Y:
Y-coordinate.
End point list