Metrohm tiamo 1.3 Manual - Manual (Page 812)

786 Configuration
6.7 Subwindow Sensors
6.7.1 General
Subwindow sensors
The subwindow Sensors contains the Sensor table with automatically recognized
and manually added sensors. It can be shown in a separate window on the pro-
gram part Configuration as a part of the Configuration view or (if not present on
the desktop) with
View, Quick access . The subwindow can be enlarged and dimin-
ished as required; it can also be maximized.
Intelligent sensors (IS)
Intelligent sensors have a datachip with stored sensor data. When connected on
intelligent devices (e.g. 857 Titrando) via 854 iConnect, they are recognized
automatically and stored in the sensor table.
Non-intelligent sensors
Non-intelligent sensors must be added manually to the sensor table.
Standard sensors
The sensor table contains the following sensors as standard; these cannot be de-
leted:
•
Conductivity sensor
• ISE electrode (ion-selective electrode)
• Metal electrode
•
pH electrode
• Temperature sensor
6.7.2 Sensor table
Contents
In the sensor table the following information about the configured sensors is
shown as standard:
Sensor name
Name of the sensor.
Sensor type
Type of the sensor. Intelligent sensors will be marked with IS and shown
automatically in green.
Measuring input
Device and measuring input to which the sensor is connected.