Metrohm tiamo 1.3 Manual - Manual (Page 431)

Commands 405
SET U
Command for Set Endpoint Titrations with potentiometric voltage measurement.
Devices
This command can be executed with the following devices which have the SET
mode:
Titrino: 702, 716, 718, 719, 720, 721, 736, 751, 758, 785, 794, 798, 799
Titrando: 808, 809, 835, 836, 841, 842, 855, 857, 888
Appearance
The command has the following appearance:
without conditioning with conditioning
Parameters
The parameters for the command SET U are configured in the following 8 tabs:
•
General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
•
Start conditions
Parameters for the measurement of the initial measured value and for defin-
ing the conditions which have to be met at the start of the titration.
•
Control parameters
Control parameter for endpoint 1 and endpoint 2 (measured value for the
endpoint, titration rate, user defined parameters, stop criterion).
•
Titration parameters
Parameters for the run of the titration.
• Stop conditions
Definitions of conditions which cause the stop of the titration.
• Conditioning
Switching conditioning on/off. Definition of start drift, drift correction and
stop conditions.
• Additional evaluations
Definition of additional methods for evaluation of the titrations curves.
• Additional measured values
Definition of additional measured values of other measuring commands
which are saved as additional column in the list of measuring points.
General/Hardware
Screenshot and parameters: see DET U - General/Hardware
Start conditions
Screenshot and parameters: see SET pH - Start conditions