Metrohm tiamo 1.3 Manual User Manual
Page 121
Sample tables
95
Sample position
[ 1 ] ... 999
Position of the sample on the rack. This number is used to move to the
sample position with the command
MOVE
. For this
Target
=
Sample position
must be set.
ID1 ... ID8
100 characters, selection from text templates
Sample identifications ID1...ID8. In this field any text can be entered, a
check of the type and limits is only made at the start of the determination.
For sample identifications of the
Date/Time
type the input must be made in
the format
YYYY-MM-DD
or
YYYY-MM-DD hh:mm:ss
. If Text templates have
been defined for sample identification then they can be selected.
Sample size
[ 1.0 ], numerical with max. 10 numbers
Sample size (weight). In this field only numbers, decimal point,
+
, –,
E
and
e
can be entered. A check of the limits is only made at the start of the deter-
mination.
Note
If a value is entered or imported into this field then in addition the time of data in-
put and the data source (
manual
,
'Name of balance'
,
'Name of barcode reader'
or
'Name of import file'
) will be automatically saved together with the determination
and shown in the subwindow
Information
as
Input date
and
Data source
.
Note
If a negative value is entered in this field (e.g. during data import from a balance
during back-weighing), then it will also be calculated as negative in the Formula
editor.
Sample size unit
16 characters, [ g ], mg, µg, mL, µL, pieces
Sample size unit (weight). Any text can be entered in this field.
Navigation
Shows the currently selected line in the sample table with the following
functions:
Jumps to first line in the sample table.
Jumps to previous line in the sample table.
Possibility of entering the required line number, which will be moved to di-
rectly when [Enter] is pressed.
Jumps to next line in the sample table. If the end of the table has been
reached then a new line will be generated automatically and also jumped
to. This increases the line number by
+1
.
Jumps to last line in the sample table.