Metrohm tiamo 1.3 Manual - Manual (Page 634)

608 Method
SEND
Command for sending event messages to commands, tracks or to tiamo.
Appearance
The command has the following appearance:
Parameters
The parameters for the command SEND are configured in the following dialog win-
dow:
•
SEND
SEND - properties
Command name
25 characters, [ Send # ]
Name of the command.
Send event messages
All the Event messages listed in the table are sent simultaneously. The table is not
editable directly.
Opening the dialog window Send event message for entering a new event
message.
Note
10 event messages can be entered at maximum.
Open the dialog window Send event message to edit the selected event
message.
Delete the selected event message.