Metrohm tiamo 1.3 Manual - Manual (Page 277)

Subwindow Determination overview 251
[ on ], off
If this option is switched on then all the axes in the curve window will be
scaled automatically. In this case the fields Start value and End value cannot
be edited.
Quantity
Command-dependent selection
Selection of the quantity to be shown on the x axis.
Label
50 characters, [ auto ]
Freely definable axis labeling for the x axis. With auto the name from the
field Quantity will be used.
Scaling
Start value
1 E-8 ... [ 0.0 ] ... 1 E+8
Initial value for scaling the x-axis.
End value
1 E-8 ... [ 1000.0 ] ... 1 E+8
Final value for scaling the y-axis.
y axis
Command type
[ DET ], MET, SET, KFT, KFC, STAT, MEAS, MEAS T/Flow, DOS
Shows the type of command for which the curve properties can be defined.
The curve properties defined by command type for the reprocessing win-
dow are saved per client.
Autoscaling
[ on ], off
If this option is switched on then all the axes in the curve window will be
scaled automatically. In this case the fields
Start value and End value cannot
be edited.
Quantity
Command-dependent selection
Selection of the quantity to be shown on the y axis.
Label
50 characters, [ auto ]
Freely definable axis labeling for the y axis. With auto the name from the
field Quantity will be used.