Metrohm tiamo 1.3 Manual User Manual

Page 48

General program functions

Without index specification, the last index is used automatically (e.g.

.EP.ERC

for

the last end point).

Identifier

Description

Commands

.BLV

Blank value of the sensor used for the command (for ISE sen-

sors only) or the blank value calculated during calibration (for
CAL LOOP Conc)

DET U, MET U,

SET U, STAT U,
MEAS U, MEAS
Conc, CAL LOOP
Conc, DOS U

.BP{#}.DME

Difference in measured values for break point # (1...9)

MET

.BP{#}.ERC

ERC or 1st derivative for break point # (1...9)

DET

.BP{#}.MEA

Measured value for break point # (1...9) in the units of the

measured value

DET, MET, MEAS

(without T/Flow)

.BP{#}.TEM

Temperature for break point # (1...9) in °C

DET, MET, MEAS
(without T/Flow)

.BP{#}.TIM

Time for break point # (1...9) in s

DET, MET, MEAS
(without T/Flow)

.BP{#}.VOL

Volume at break point # (1...9) in mL

DET, MET

.BSY

Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not present) = Command has never
been started

All except START
and END

.CBY

Command status; 1 = conditioning active, 0 = condition-
ing not active

SET, KFT, KFC

.COK

Command status; 1 = conditioning criterion fulfilled, 0 =

conditioning criterion not fulfilled

SET, KFT, KFC

.CONC

Concentration of the solution used for the command

DET, MET, SET,
KFT, STAT, ADD,
DOS, LQH,
STDADD

.CYL

Cylinder volume of the exchange or dosing unit used for the
command

DET, MET, SET,
KFT, STAT,
STDADD dos,
STDADD auto,

ADD, DOS, LQH,
PREP, EMPTY

.DBL

Total duration for processing the command in s

DET, MET, SET,
KFT, KFC, STAT,
MEAS, CAL MEAS,

STDADD, DOS

.DRI

Current or last drift for drift correction in µL/min

SET, KFT, KFC

.DSC

Duration for processing all start conditions in s

DET, MET, SET,
KFT, STAT

.DTI

Time for the drift correction (time from start of titration until end

of command) in s

SET, KFT, KFC

.EGF

Last measured gas flow (measured value after processing the
command) in mL/min

MEAS T/FLow

.EME

Final measured value (measured value after processing the
command) in the units of the measured value

DET, MET, SET,
KFT, KFC, STAT,

MEAS, CAL MEAS,
STDADD, DOS