Metrohm tiamo 1.3 Manual - Manual (Page 527)

Commands 501
General/Hardware
The general parameters for the control device, the sensor and the stirrer are de-
fined on this tab.
Command name
25 characters, [ MEAS Upol # ]
Name of the command.
Device
Device name
Device name, [ not defined ]
Selection of a device from the device table. Only those devices being able
to execute the command are selectable. Additionally,
not defined can be se-
lected. In this case, the device name must be assigned by the user at the
start of the method.
Device type
Device types, [ Titrando ]
Display or selection of the device type. If a device is selected under Device
name , this parameter is not editable any more. The device type belonging to
the selected device is displayed instead.
If the option
not defined is selected as Device name , all device types being
able to execute the command can be selected independently from the de-
vices in the device table.
Sensor
Measuring input
[ 1 ] ... 2 (Titrando)
[ 1 ] ... 2, diff. (Titrino)
Selection of the measuring input to which the sensor is connected.
Sensor
Sensor name, [ Metal electrode ]
Selection of a sensor of type Metal electrode from the list of sensors defined
in the sensor table.
U(pol)
-1'250 ... [ 400 ] ... 1'250 mV (Titrando, increment = 25 mV)
-1'270 ... [ 400 ] ... 1'270 mV (Titrino, increment = 10 mV)