Metrohm tiamo 1.3 Manual - Manual (Page 791)

Subwindow Devices 765
RS 232
COM Port
COM1, COM2, ..., [ first free COM port ]
Selection of the serial interface on the PC to which the device is connected.
Baud rate
300, 600, 1200, 2400, 4800, [ 9600 ], 19200, 38400, 57600, 115200
Transmission speed.
Data bit
7, [ 8 ]
Number of data bits.
Parity
[ None ], Odd, Even
Type of parity check.
Stop bit
[ 1 ], 2
Number of stop bits.
Handshake
[ None ], HW, SW
Type of data transmission protocol.
Timeout
1000 ... [ 2000 ] ... 9000 ms
Maximum waiting time for receiving characters. If this time is exceeded the
reception will be stopped.
Terminator for send
20 characters, \0D, \0D\0A, \0D\0A\0A, \0D\0D\0A ( \0D = CR, \0A = LF)
Final character for transmission in hexadecimal code.
Terminator for receive
20 characters, \0D, \0D\0A, \0D\0A\0A, \0D\0D\0A ( \0D = CR, \0A = LF)
Final character for reception in hexadecimal code.
Code page
[ Cp437 ], Cp850, Cp852, ASCII
Code page used for the data transmission.
Send characters one by one
on, [ off ]
If this option is enabled every character is sent separately. Before sending
the next character, the Delay time is waited for.
Delay time
[ 0 ] ... 9000 ms
Waiting time before sending the next character.