Metrohm tiamo 1.3 Manual - Manual (Page 697)

Configuration data 671
Note
Input lines that are not of interest, or for which no defined condition can be pre-
dicted, should be masked with an asterisk
* .
Templates for output lines
With the menu item Tools, Templates, Output lines the dialog window Templates for
output lines opens in which the client-specific bit-pattern for setting remote output
signals can be defined; these can be selected with the command CTRL and in
Manual Control.
Template table
The table with the defined templates cannot be edited, however, with a mouse
click on the column title it can be sorted according to the selected column in ei-
ther an increasing or decreasing sequence.
Generates a new template (see below).
Edits the selected template (see below).
Deletes the selected template.
Generate new template or edit template
With or the dialog window New template or Edit template opens for
entering a new template or for editing an existing template respectively.
Signal name
25 characters
Name of template for the output signal.
Output signal
Bit-pattern with exactly 14 characters (0, 1, *, p), [ ************** ]
Entry of the bit-pattern for the output signal with exactly 14 characters.
The following characters can be entered
0 = line inactive,
1 = line active,