Metrohm tiamo 1.3 Manual - Manual (Page 234)

208 Database
Scaling
Start value
1 E-8 ... [ 0.0 ] ... 1 E+8
Initial value for scaling the x-axis.
End value
1 E-8 ... [ 1000.0 ] ... 1 E+8
Final value for scaling the x-axis.
y-axis
Parameters for the graphical presentation of the superimposed curves on the y
axis.
Template name
50 characters
Name for the curve overlay template which is saved in the configuration da-
tabase per client.
Command type
Selection of command types
Selection of the command type from which curves are to be superimposed.
Autoscaling
[ on ], off
If this option is switched on then the x axis in the curve window will be
scaled automatically. In this case the fields
Start value and End value cannot
be edited.
y Axis
Quantity
Command-dependent selection
Selects the quantity to be shown on the y axis.
Label
25 characters, [ auto ]
Freely definable axis labeling for the y axis. With auto the label from the field
Quantity will be used.
Show measuring points
[ on ], off
If this option is switched on then the individual measuring points will be
shown on the curve.
Note
For curves with more than 100 measuring points, the individual measuring points
will not be shown any more, even if this option is enabled.