Metrohm tiamo 1.3 Manual - Manual (Page 395)

Commands 369
DET Upol
Command for Dynamic Equivalence Point Titrations with amperometric meas-
urement (selectable polarization voltage).
Devices
This command can be executed with the following devices which have the DET
mode:
Titrino: 716, 721, 736, 751, 785, 794, 798, 799
Titrando: 808, 809, 835, 836, 855, 857, 888
Appearance
The command has the following appearance:
Parameters
The parameters for the command DET Upol are configured in the following 7 tabs:
• General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
• Start conditions
Parameters for the measurement of the initial measured value and for defin-
ing the conditions which have to be met at the start of the titration.
• Titration parameters
Parameters for the run of the titration.
• Stop conditions
Definitions of conditions which cause the stop of the titration.
•
Potentiometric evaluation
Parameters for the potentiometric evaluation of titration curves.
•
Additional evaluations
Definition of additional methods for evaluation of the titrations curves.
• Additional measured values
Definition of additional measured values of other measuring commands
which are saved as additional column in the list of measuring points.