Metrohm tiamo 1.3 Manual - Manual (Page 616)

590 Method
FLOW - properties
Command name
25 characters, [ Gas flow # ]
Name of the command.
Device
Device name
Device name, [ not defined ]
Selection of a 774 Oven Sample Processor from the device table. Addition-
ally,
not defined can be selected. In this case, the device name must be as-
signed by the user at the start of the method.
Device type
774 Oven Sample Processor
Display of the device type. If a device is selected under Device name , this
parameter is not editable any more. The device type belonging to the se-
lected device is displayed instead.
If the option
not defined is selected as Device name , all device types being
able to execute the command can be selected independently from the de-
vices in the device table.
Gas
Gas type
[ air ], nitrogen, other gas
Gas type of the carrier gas.
Gas flow factor
0.001 ... [ 1.000 ] ... 9.999
Factor for the correct determination of the gas flow. This parameter is only
visible for Gas type = other gas . The values for frequently used carrier gases
are listed in the Instructions for Use for the 774 Oven Sample Processor.
Gas flow
Inlet
Selection of the inlet of the carrier gas:
[ pump ]
Use of ambient air as carrier gas.
valve
Use of gas out of a compressed gas cylinder as carrier gas.
Switch on
[ on ], off
Switch on the gas flow.
Switch off
on, [ off ]