MTS Series 793 Application User Manual
Page 130
MTS MultiPurpose TestWare®
About Runing Multiple Tests Against the Same MPT
Working with MPT Specimens
130
5. In the Load Specimen window, click Procedure assigned to the Specimen.
For more information
For more information on loading procedures, see
About Runing Multiple Tests Against the Same MPT Specimen
You may want to run a procedure against an MPT specimen more than once, or
you may want to run different tests against the same MPT specimen. In either
case, it is important to note how the data files in your MPT specimen are affected
when you do this.
By default, if you run another test against your MPT specimen, the MPT
application:
•
Appends new test information to the existing data file and log file .
•
Writes over the information in the procedure snapshot file and dynamic state
snapshot file with the new test information.
Note
You can configure whether new data overwrites or appends to the
previous data with the MPT Options Editor.
For more information
For more information about the using the MPT Options Editor, see
See
See
See
See