MTS Series 793 Application - Manual (Page 376)

MTS MultiPurpose TestWare®
Program Event Process
Event Process Descriptions 376
How to Define a Program Event Process
1. Drag the icon from the Process Palette to your procedure table.
2. Click the process icon in your procedure table or in the navigation pane.
3. Click the Settings tab.
4. Hold the Ctrl key and click the program events you want to monitor.
5. Under Trigger Mode, set the trigger mode.
6. Click the General tab.
7. In the Name box, type a name for this process. (You can also name the
process in the procedure table.)
8. Select the Process Enabled check box. (If this box is cleared, the process
will not run.)
9. In the Execute Process box, type number of times you want the process to
run.
Note Repeating the process will have no effect if you selected Trigger
Continuously in step 5.
10. Optional—In the Counter Type list, click a counter type.
11. Optional—If you enabled a counter, type a Counter Label.
12. Set the desired Start and Interrupt signals for the process in the procedure
table.