MTS Series 793 Application - Manual (Page 423)

Start Application Process
MTS MultiPurpose TestWare® Other Process Descriptions 423
General tab
Wait for application to
complete When enabled, the process will wait until the application has completed before
completing (before it sends out its “done” trigger).
When disabled, the process will complete immediately after starting the
specified application.
Resume Options Defines how the process will resume when the procedure has been stopped and
unlocked while waiting for the selected application to complete.
Start application and wait for it to complete–causes the process to restart the
application and complete when the application has completed.
Proceed as if application has completed–causes the process to complete
immediately.
Prompt operator for resume option–displays a message which causes the
operator to either:
• Restart the application
OR
• Proceed as if the application has completed.
Settings Tab (part 3 of 3)
I TEM D ESCRIPTION
General Tab
I TEM D ESCRIPTION
Name Specifies the process name displayed on the Procedure or Group process
window.
Process Enabled Enables the process. (Clear this box to disable the process.)
Execute Process Specifies the number of times the process will be run.
Counter Type Enables a process counter.
Options are None, Transient, or Fixed. Transient counters are displayed only
when the process is active. Fixed counters are displayed throughout the test.
Counter Label Names the counter.
When you run the test, this name appears under Sequence Counters on the
MPT control panel.
Note If this box is blank, the process name is used as the counter label.