MTS Series 793 Application - Manual (Page 194)

MTS MultiPurpose TestWare®
Cyclic Command Process
Command Processes 194
17. Click the General tab.
18. In the Name box, type a name for this process. (You can also name the
process in the procedure table.)
19. Select the Process Enabled check box. (If this box is cleared, the process
will not run.)
20. In the Execute Process box, type number of times you want the process to
run.
21. Optional—In the Counter Type list, click a counter type.
22. Optional—If you enabled a counter, type a Counter Label.
23. Set the desired Start and Interrupt signals for the process in the group or
procedure table.