MTS Series 793 Application - Manual (Page 217)

External Command Process
MTS MultiPurpose TestWare® Command Processes 217
General tab
Channels tab Displays the channels available to this process. Use the arrow keys to move
desired channels from the Available list to the Included list.
Note Only channels in station configurations that have an external command
signal defined in Station Builder are available to this process.
Setpoint Defines the setpoint value for the selected channel.
The value entered in the setpoint box will overwrite the system setpoint value
when the process becomes active.
Span Defines the span value for the selected channel.
The value entered in the Span box will overwrite the system span value when
the process becomes active.
Scaling Tab (part 2 of 2)
I TEM D ESCRIPTION
General Tab
I TEM D ESCRIPTION
Name Specifies the process name displayed on the Procedure or Group process
window.
Process Enabled Enables the process. (Clear this box to disable the process.)
Execute Process Specifies the number of times the process will be run.
Counter Type Enables a process counter.
Options are None, Transient, or Fixed. Transient counters are displayed only
when the process is active. Fixed counters are displayed throughout the test.
Counter Label Names the counter.
When you run the test, this name appears under Sequence Counters on the
MPT control panel.
Note If this box is blank, the process name is used as the counter label.