MTS Series 793 Application - Manual (Page 95)

How to Set/Edit the Interrupt Signal
MTS MultiPurpose TestWare® Working with MPT Processes 95
How to Set/Edit the Interrupt Signal
1. To specify the interrupt signal(s), double-click the Interrupt list box to
display the signal list.
2. In the signal list, hold the Ctrl key and click each signal you want to
interrupt the procedure. (If you select multiple signals, the procedure
interrupts when any of the selected signals are received.)
3. Press Enter.
If you want to clear your interrupt signal selections:
1. Double-click the signal name to display the signal list.
2. In the signal list, hold the Ctrl key and click each signal you want to remove
from the list.
3. Press Enter.
Note You can deselect all of the signals highlighted and close the list by
double-clicking any of the individual selections highlighted in the list.
How to Specify/Change the Procedure Done Signal
1. To specify the procedure done signal(s), double-click the Procedure is done
when box to display the signal list.
2. In the signal list, hold the Ctrl key and click each signal you want to end the
procedure. (If you select multiple signals, the procedure ends when any of
the selected signals are received.)
3. Press Enter.
If you want to clear your procedure done signal selections:
1. Double-click the signal name to display the signal list.
2. In the signal list, hold the Ctrl key and click each signal you want to remove
from the list.
3. Press Enter.
Note You can deselect all of the signals highlighted and close the list by
double-clicking any of the individual selections highlighted in the list.