MTS Series 793 Application - Manual (Page 288)

MTS MultiPurpose TestWare®
Timed Acquisition Process
Data Acquisition Process Descriptions 288
11. In the Buffer Type list, click the buffer type.
12. Optional—If desired, enable Write First Data Header Only checkbox.
This feature aids data sorting and analysis.
13. Optional—Click the Output Units tab.
Change the unit assignment set if you want. Each data acquisition process
can use a different unit assignment set.
14. Click the General tab.
15. In the Name box, type a name for this process. (You can also name the
process in the procedure table.)
16. Select the Process Enabled check box. (If this box is cleared, the process
will not run.)
17. In the Execute Process box, type the number of times you want the process
to run.
18. Optional—In the Counter Type list, click a counter type.
19. Optional—If you enabled a counter, type a Counter Label.
20. Set the desired Start and Interrupt signals for the process in the procedure
table.
For more information See “Data Destination” on page 275.