MTS Series 793 Application User Manual
Page 30
MTS MultiPurpose TestWare®
The MultiPurpose TestWare Interface
About MultiPurpose TestWare
30
For more information
For more information about MPT specimens, see
Procedure Name
Displays the name of the current procedure selection. The procedure name is
established when you save the procedure.
Procedure State
Displays the current state of the procedure, which may be one of the following:
•
Reset—The test is at the beginning but has not been started.
•
In Progress—The test has started but is not yet completed.
•
Done—The test has been completed.
Note
To run the procedure on the same MPT specimen again, press Reset.
Otherwise, create a new MPT specimen for the next instance of
running the same procedure.
•
Error—An error has occurred (you must click Reset to run the test
again).
MPT Specimen Panel (part 2 of 2)
I
TEM
D
ESCRIPTION