MTS Series 793 Application - Manual (Page 291)

Max/Min Acquisition Process
MTS MultiPurpose TestWare® Data Acquisition Process Descriptions 291
General tab
Signals Tab Selects signals from which this process acquires data. Use the left and right
arrows to move desired signals from the Available list to the Included list.
Note The order of the signals in the Included list determines the order of the
columns of data in your data file. Use the up and down arrows to arrange
signals in the desired order.
List Filter With the List Filter, you can pare the list of Available signals according to text
you type in the entry box. Type text that describes the signal(s) you wish to
display.
For example, typing force displays all signals that include “force” in their labels.
You can also type a part of a signal description to display a signal type. For
example, to display displacement signals, you can type disp rather than
“displacement”.
General Tab
I TEM D ESCRIPTION
Name Specifies the process name displayed on the Procedure or Group process
window.
Process Enabled Enables the process. (Clear this box to disable the process.)
Execute Process Specifies the number of times the process will be run.
Counter Type Enables a process counter.
Options are None, Transient, or Fixed. Transient counters are displayed only
when the process is active. Fixed counters are displayed throughout the test.
Counter Label Names the counter.
When you run the test, this name appears under Sequence Counters on the
MPT control panel.
Note If this box is blank, the process name is used as the counter label.