MTS Series 793 Application - Manual (Page 372)

MTS MultiPurpose TestWare®
Peak/Valley Change Detector Process
Event Process Descriptions 372
12. Optional—Click the Command tab, click a Channel Reference signal and
type a Cycle Time Out value.
13. Click the General tab.
14. In the Name box, type a name for this process. (You can also name the
process in the procedure table.)
15. Select the Process Enabled check box. (If this box is cleared, the process
will not run.)
16. In the Execute Process box, type number of times you want the process to
run.
Note Repeating the process will have no effect if you selected Trigger
Continuously in step 10.
17. Optional—In the Counter Type list, click a counter type.
18. Optional—If you enabled a counter, type a Counter Label.
19. Close the parameters window, and set the desired Start and Interrupt
signals for the process in the procedure table.