MTS Series 793 Application - Manual (Page 103)

How to Disable Processes
MTS MultiPurpose TestWare® Working with MPT Processes 103
How to Disable Processes
You can disable a process in the following ways:
1. On the General tab in the process Parameters window, clear Process
Enabled.
This prevents the process from starting and generating any signals used to
start or interrupt another process. If you disable a command process this
way, all subsequent command processes are disabled. When you do this, the
process appear swith a red “X” in the left margin of the Procedure (or
Group) table.
2. On the General tab of the process’ Parameters window, type zero.
This method starts the process, but immediately sends out the process
“done” signal to other processes. This method works best if you want to
disable a command process without disabling all subsequent command
processes. When you do this, the process appears with a downward pointing
green arrow in the left margin of the Procedure (or Group) table.
3. On the procedure table, select the process, right-click the mouse, then click
the Enable selection to uncheck it. When you do this, the process appears
with a red “X” in the left margin of the Procedure (or Group) table.