General tab for more information – MTS Series 793 Application User Manual
Page 403
Program Control Process
MTS MultiPurpose TestWare®
Other Process Descriptions
403
General tab
For more information
For more information on Actions, see
“How to Use Actions with Processes”
Message
Defines the content of the message written to the log.
Include Counters
*
Includes counter information with the message written to the message log.
Note
This option can be used to periodically log counter information.
* If the Program Control process is configured to include counters and log on a transition state change,
your log will contain two similar messages each time the state changes. This occurs because all
state transitions are automatically logged with counter information. Keep in mind that the automatic
logs are displayed as Information, while the Program Control logs are displayed in the severity level
you specify (Information, Warning, Error, or Diagnostic). This allows you discern between these log
entries if desired.
Action Tab (part 3 of 3)
I
TEM
D
ESCRIPTION
General Tab
I
TEM
D
ESCRIPTION
Name
Specifies the process name displayed on the Procedure or Group process
window.
Process Enabled
Enables the process. (Clear this box to disable the process.)
Execute Process
Specifies the number of times the process will be run.
Counter Type
Enables a process counter.
Options are None, Transient, or Fixed. Transient counters are displayed only
when the process is active. Fixed counters are displayed throughout the test.
Counter Label
Names the counter.
When you run the test, this name appears under Sequence Counters on the
MPT control panel.
Note
If this box is blank, the process name is used as the counter label.