MTS Series 793 Application - Manual (Page 413)

Operator Information Process
MTS MultiPurpose TestWare® Other Process Descriptions 413
Parameters tab
Available/Included The Available list displays the variable parameters that you can assign
to the Operator Information process. The Included list displays the
variable parameters that can be used by the Operator Information
process.
Editable Note Enabling the Editable control does not automatically make all
the variables in the included list editable. Enabling the
Editable control applies only to the variables selected
(highlighted) in the Included list.
When enabled (checked) for the selected variable parameters in the
Included list, allows you to edit variable values when displayed in the
variable run-time display.
Variables Tab (part 2 of 2)
I TEM D ESCRIPTION
Parameters Tab (part 1 of 3)
I TEM D ESCRIPTION
Upgrade to Variables Note This control is available only if the controller is equipped with
the variables feature (keyed option), and if the test procedure
includes non-variable parameters.
Note When upgrading a Real or Integer parameter to a variable, the
Inclusive attribute is automatically enabled for the parameter’s
range. That is, the specified Minimum and Maximum limit
values are automatically included within the parameter’s
range.
Converts the parameters currently assigned to the Operator
Information process to variables.
Items Displays the Operator Information process toolbar and your current
items.
Add/Add after selection
Creates a new item.
When the Items list is empty, this button is labeled “Add”. Once an
item has been added, it changes to “Add after selection.” If you select
an item and then click this button, a new item will be added after the
selected item.
Add before selection
Adds a new item before the selected item.