MTS Series 793 Application - Manual (Page 209)

Profile Process
MTS MultiPurpose TestWare® Command Processes 209
Note The Execute Process value multiplies the Total Passes in the
Command parameters. If the Execute Process parameter is set to 10
and the Total Passes is set to 5, a total of 50 passes will occur.
17. Optional—In the Counter Type list, click a counter type.
18. Optional—If you enabled a counter, type a Counter Label.
19. Set the desired Start and Interrupt signals for the process in the group or
procedure table.
20. Optional—If the Profile process is equipped with manual compensation,
adjust the Setpoint and Span sliders in the manual compensation panel as
desired while the process is running.
How to Use the Manual Command Feature
Note Manual compensation will be available only if the “Manual Compensation
(MPT Profile Process)” feature is enabled during installation.
With the manual compensation feature you can manually adjust the setpoint and
span of the selected channel while the Profile process is running.
How to apply manual
setpoint and span values
to a profile
To choose the manual compensation feature, you select Manual in the Adaptive
Compensators list on the Command tab of the Profile process. When you select
this feature, a Manual Compensation panel appears (under the Sequence
Counters panel) when the test procedure is locked. MPT ramps from current
levels to manual adjustment levels according to the Setpoint and Span times
specified in the Command Options tab of the Channel Options window in
Station Manager.