HP Storage Essentials NAS Manager Software - Manual (Page 174)

Discovering Applications, Backup Servers and Hosts 142
1. Select Options > Protocol Settings > Storage Essentials > Global Application Discovery
Settings
.
2. To assign a new port, click the Create for the Oracle Information table.
3. Type the new port number and click OK.
4. If necessary, click the button to remove the old port number.
5. Verify all elements have been discovered by clicking the Start Discovery button.
See ” Troubleshooting Discovery and Discovery Data Collection/Get Details ” on page 673 for more
information.
Adding/Modifying Microsoft Exchange Domain Controller Access
To obtain information about your Microsoft Exchange servers, you must provide the user name and
password for at least a primary domain controller, in addition to a DNS name, as described in the
following steps.
Keep in mind the following:
• The hosts should recognize the management server by name, as a reverse look-up is required by
operating system security as well as Microsoft Exchange.
• Make sure you provide just the user name and not the domain name when discovering Microsoft
Exchange servers.
To provide information about the Microsoft Exchange servers:
1. Do one of the following:
• Discovery from HP SIM - Click Options > Protocol Settings > Storage Essentials >
Global Application . To select a target, you must have at least one element designated as a
server, workstation or desktop. If you see the message, “No Targets Currently Selected,”
change your element from unknown to either a server, workstation or desktop. Click Run
Now
. Refer to the documentation for HP Systems Insight Manager.
• Discovery from HP SE - Click Tools > Storage Essentials > Home > Discovery >
Setup .
2. In the Microsoft Exchange Configuration section, click the Edit button.
3. Under the Primary Domain Controller section, perform the following steps:
a. In the Host Name field, type the fully qualified DNS name for the domain controller.
b. In the User Name field, type the user name for accessing the Microsoft Exchange server.
c. In the Domain Password field, type the corresponding password for accessing the
Microsoft Exchange server.
d. In the Verify Password field, re-type the password for verification.
4. Under the Backup Domain Controller section, perform the following steps:
a. In the Host Name field, type the fully qualified DNS name for the domain controller.
b. In the User Name field, type the user name for accessing the Microsoft Exchange server.
c. In the Domain Password field, type the corresponding password for accessing the
Microsoft Exchange server.