IAI America REXT - Manual (Page 313)

Part 2 Startup Chapter
Chapter 5 Network Setup
287
Part 2 Startup Chapter
„ Example of Using in Positioner 2 Mode, Solenoid Valve Mode 1 or Solenoid Valve Mode 2
If a 0 number of axis is set in the simple direct/positioner 1 mode or direct numerical specification mode (positioning
mode), the positioner 2 mode, solenoid valve mode 1 or solenoid valve mode 2 can be set.
*3 Every time a cell is clicked, its status cycles in the sequence of blank (not selected) Æ * (selected) Æ (*) (reserved
axis) Æ blank.
„ Setting of reserved axes
You can set reserved axes in consideration of future expansion of axis configuration.
Click the cell of each applicable axis to display the (*) mark.
An example of setting axes 2 to 3 as reserved axes in the positioner 1 mode is shown below.
*4 Any axis of axis No. 0 to 15 can be set as a reserved axis.
The data areas of reserved axes are also treated as occupied.
Can be set when the values in
these fields are 0.
Select a desirable mode.
Set as reserved axes *4
-313-