IAI America REXT - Manual (Page 264)

Part 2 Startup Chapter
Chapter 1 Overview
240
Part 2 Startup Chapter
Part 2 Startup Chapter
Chapter 1 Overview
1.1 Required Tools
The tools needed to configure a ROBONET system and start the system include the PC software, teaching pendant, and
ROBONET gateway parameter setting tool, as specified below.
[1] PC software RCM-101-** Version 6.00.04.00 or later
[2] Teaching pendant
x RCM-T/TD Version 2.06 or later
x RCM-E/P Version 2.08 or later
x CON-T/TD Version 1.00 or later
[3] ROBONET gateway parameter setting tool Version 1.0.2.0 or later
Setting of the positioner 2 mode, setting of the reserved axes and operation of files are supported when the version
of the parameter setting tool is 1.0.3.0 or later. However, the firmware version of the Gateway R unit must be .000B
or later at the same time.
Solenoid valve mode 1, solenoid valve mode 2 and special parameter functions are supported by parameter setting
tools of version 1.0.4.0 and later. However, the firmware version of the Gateway R unit must be 000F or later.
This tool is provided in the CD-ROM containing PC software (Control No. CDCON00006 or later). You can also
download the tool from our website.
-264-