Dell PowerEdge FX2/FX2s - Manual (Page 291)

Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.6(0.0) Supported on the FN2210S Aggregator.
Version 9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE
Switch with the FC Flex IO module.
Example
Dell(conf)#do show fc sw
Switch Mode : NPG
Switch WWN : 10:00:00:1e:c9:f1:00:d7
show npiv devices
Display the FCoE and FC devices currently logged in to an FN I/O Aggregator Switch with the FC Flex IO
module NPIV proxy gateway.
Syntax show npiv devices [brief]
Parameters
brief Displays an overview of current server CNA-fabric
connections over an FN I/O Aggregator with the FC Flex IO
module NPIV proxy gateway.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.6.
(0.0) Supported on the FN2210S Aggregator.
Version 9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE
Switch with the FC Flex IO module.
Usage
Information
Use the show npiv devices command to display information on the server CNA,
server-facing Ethernet and fabric-facing FC ports, and the SAN fabric in each
server-fabric connection over an FN I/O Aggregator with the FC Flex IO module
NPIV proxy gateway.
The following table describes the show npiv devices brief output shown in
the example below.
Field Description
ENode-Intf FN I/O Aggregator with the FC Flex IO module Ethernet
interface (slot/port) to which a server CNA is connected.
291