Dell PowerEdge FX2/FX2s - Manual (Page 212)

Undo a configuration with the no aaa authorization commands {level|
{name|default} {local | tacacs+ | none} command.
Parameters
commands
level Enter the keyword commands then the command privilege
level for command level authorization.
name Define a name for the list of authorization methods.
default Define the default list of authorization methods.
local Use the authorization parameters on the system to perform
authorization.
tacacs+ Use the TACACS+ protocol to perform authorization.
none Enter the keyword none to apply no authorization.
Defaults none
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.6.
(0.0) Supported on the FN I/O Aggregator.
Version 9.5(0.0) Added support for roles on the Z9000, S6000, S4820T,
S4810, MXL
Version 9.2(1.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.0 Added support for RADIUS.
aaa authorization config-commands
Set parameters that restrict (or permit) a user’s access to EXEC level commands.
Syntax aaa authorization config-commands
212