Dell PowerEdge FX2/FX2s - Manual (Page 370)

Parameters
mac-address Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn
format.
output
interface Enter the keyword output then one of the following
interfaces for which traffic is forwarded:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
vlan vlan-id Enter the keyword vlan then a VLAN ID number from 1 to
4094.
Defaults Not configured.
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
mac-address-table station-move refresh-arp
Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs
due to a topology change.
Syntax [no] mac-address-table station-move refresh-arp
Defaults none
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information For details about using this command, refer to the “NIC Teaming” section of the
Layer 2 chapter in the Dell Networking OS Configuration Guide.
show mac-address-table
Display the MAC address table.
Syntax show mac-address-table [dynamic | static] [address mac-address
| interface interface | vlan vlan-id] [count [vlan vlan-id]
[interface interface-type [slot [/port]]]]
Parameters
dynamic (OPTIONAL) Enter the keyword dynamic to display only
those MAC addresses the switch dynamically learns.
Optionally, you can also add one of these combinations:
370