Dell PowerEdge FX2/FX2s - Manual (Page 55)

Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information The hostname is used in the prompt.
ip telnet server enable
Enable the Telnet server on the switch.
Syntax ip telnet server enable
To disable the Telnet server, use the no ip telnet server enable command.
Defaults Enabled
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
ip telnet source-interface
Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.
Syntax ip telnet source-interface interface
Parameters
interface Enter the following keyword and slot/port or number
information:
• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Related
Commands telnet — telnets to another device.
55