Dell PowerEdge FX2/FX2s - Manual (Page 251)

01:02:00: %STKUNIT0-M:CP %IFMGR-1-DEL_PORT: Removed port: Te
1/1-32,41-56
01:02:00: %STKUNIT0-M:CP %CHMGR-2-STACKUNIT_DOWN: Stack unit 1
down - reset
01:02:00: %STKUNIT1-S:CP %IFMGR-1-DEL_PORT: Removed port: Te
1/1-32,41-56
01:02:05: %I/O-Aggregator:0 %IFAGT-5-STACK_PORT_LINK_DOWN:
Changed stack port
state to down: 0/10
01:02:11: %STKUNIT0-M:CP %POLLMGR-2-ALT_STACK_UNIT_STATE:
Alternate Stack-unit is
not present
Dell#01:02:12: %STKUNIT0-M:CP %CHMGR-2-STACKUNIT_DOWN: Stack
unit 1 down - card
removed
Related
Commands
reload — reboots the system.
power-cycle stack-unit — resets the designated stack member.
show system stack-ports
Display information about the stacking ports on all switches in the FN I/O Aggregator switch stack..
Syntax show system stack-ports [status | topology]
Parameters
status (OPTIONAL) Enter the keyword status to display the
command output without the Connection field.
topology (OPTIONAL) Enter the keyword topology to limit the table
to just the Interface and Connection fields.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.6.
(0.0) Supported on the FN I/O Aggregator.
Usage
Information
This command is supported on the FN410S and the FN410T Aggregators.
The following describes the show interfaces command shown in the following
example.
Field Description
Topology Lists the topology of stack ports connected: Ring, Daisy
chain, or Standalone.
251