Dell PowerEdge FX2/FX2s - Manual (Page 459)

Usage
Information
When you create a VLT domain on a switch, Dell Networking OS automatically
assigns a unique unit ID (0 or 1) to each peer switch. The unit IDs are used for
internal system operations. Use the unit-id command to explicitly configure the
unit ID of a VLT peer. Configure a different unit ID (0 or 1) on each peer switch.
To minimize the time required for the VLT system to determine the unit ID assigned
to each peer switch when one peer reboots, use this command.
vlt domain
Enable VLT on a switch, configure a VLT domain, and enter VLT-domain configuration mode.
Syntax vlt domain domain-id
Parameters
domain-id Enter the Domain ID number. Configure the same domain ID
on the peer switch. The range of domain IDs is from 1 to
1000.
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information The VLT domain ID must be the same between the two VLT devices. If the domain
ID is not the same, a syslog message is generated and VLT does not launch.
vlt-peer-lag port-channel
Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to
an attached device.
Syntax vlt-peer-lag port-channel id-number
Parameters
id-number Enter the respective vlt port-channel number of the peer
device.
Defaults Not configured.
Command
Modes INTERFACE PORT-CHANNEL
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
459