Dell PowerEdge FX2/FX2s - Manual (Page 362)

To return to the default value, use the no ip igmp querier-timeout
command.
Parameters
seconds Enter the number of seconds the router must wait to
become the new querier. The range is from 60 to 300. The
default is 125 seconds.
Defaults 125 seconds
Command
Modes INTERFACE
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
ip igmp query-interval
Change the transmission frequency of IGMP general queries the Querier sends.
Syntax ip igmp query-interval seconds
To return to the default values, use the no ip igmp query-interval
command.
Parameters
seconds Enter the number of seconds between queries sent out. The
range is from 1 to 18000. The default is 60 seconds.
Defaults 60 seconds
Command
Modes INTERFACE
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.. This command is
supported in Programmable-Mux (PMUX) mode only.
ip igmp query-max-resp-time
Set the maximum query response time advertised in general queries.
Syntax ip igmp query-max-resp-time seconds
To return to the default values, use the no ip igmp query-max-resp-time
command.
Parameters
seconds Enter the number of seconds for the maximum response
time. The range is from 1 to 25. The default is 10 seconds.
Defaults 10 seconds
362