Dell PowerEdge FX2/FX2s - Manual (Page 39)

2 Success
3 Not present
4 Not present
5 Not present
Power-cycling the unit(s).
Dell#
Example
(NvRAM, single
unit)
Dell#restore factory-defaults stack-unit 1 nvram
**************************************************************
* Warning - Restoring factory defaults will delete the
existing *
* persistent settings (stacking, fanout, etc.) *
* After restoration the unit(s) will be powercycled
immediately. *
* Proceed with caution ! *
**************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
1 Success
Power-cycling the unit(s).
Dell#
show boot system
Displays information about boot images currently configured on the system.
Syntax show boot system stack-unit {0-5 | all}
Parameters
0–5 Enter this information to display the boot image information
of only the entered stack-unit.
all Enter the keyword all to display the boot image information
of all the stack-units in the stack.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Example
Dell#show boot system stack-unit all
Current system image information in the system:
=============================================
Type Boot Type A B
---------------------------------------------
Stack-unit 0 is not present.
Stack-unit 1 DOWNLOAD BOOT 9-1-0-218 9-1-0-202
Stack-unit 2 is not present.
Stack-unit 3 is not present.
39