Dell PowerEdge FX2/FX2s - Manual (Page 357)

The following describes the do show interfaces command shown in the
following example. This example shows output with “Hybrid” as the newly added
value for 802.1QTagged. The options for this field are:
• True — port is tagged
• False — port is untagged
• Hybrid — port accepts both tagged and untagged frames
The following describes the interface vlan command shown in the following
example. This example shows unconfiguration of the hybrid port using the no
portmode hybrid command.
NOTE: Remove all other configurations on the port before you can remove
the hybrid configuration from the port.
Example
Dell(conf-if-te-0/2)#show config
!
interface TenGigabitEthernet 0/2
mtu 12000
portmode hybrid
switchport
flowcontrol rx on tx off
!
protocol lldp
advertise management-tlv management-address system-name
dcbx port-role auto-downstream
no shutdown
Dell(conf-if-te-0/2)#vlan tagged 5
Dell(conf-if-te-0/2)#vlan untagged 10
Dell(conf-if-te-0/2)#
Dell(conf-if-te-0/2)#do show vlan
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port
Mirroring VLANs, P - Primary, C - Community, I - Isolated
O - Openflow
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
o - OpenFlow untagged, O - OpenFlow tagged
G - GVRP tagged, M - Vlan-stack, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT
untagged, V - VLT tagged
NUM Status Description Q Ports
* 1 Active U Po128(Te 0/9-11)
U Te
0/1,3-8
5 Active T Po128(Te 0/9-11)
T Te 0/2
10 Active T Po128(Te 0/9-11)
U Te 0/2
Dell(conf-if-te-0/2)#
357