Dell PowerEdge FX2/FX2s - Manual (Page 167)

13
IPv4 Routing
The aggregator supports both IPv4 and IPv6 routing and these are used only for the management
purpose.
This chapter describes the IPv4 related commands. They are:
• clear tcp statistics
• debug ip dhcp
• debug ip icmp
• ip route
• management route
• show arp
• show ip management-route
• show ip multicast-cam stack-unit
• show ip interface
• show ip route
• show tcp statistics
clear tcp statistics
Clear the TCP counters.
Syntax clear tcp statistics
Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
debug ip dhcp
Enable debug information for DHCP relay transactions and display the information on the console.
Syntax debug ip dhcp
Parameters
debug ip dhcp To disable debug, use the no debug ip dhcp command.
167