Dell PowerEdge FX2/FX2s - Manual (Page 386)

Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the
communication between servers and a SAN fabric.
show fcoe-map — displays the Fibre Channel and FCoE configuration parameters in
FCoE maps.
keepalive
In an FCoE map, enable the monitoring of FIP keepalive messages (if it is disabled).
Syntax keepalive
Parameters None
Defaults FIP keepalive monitoring is enabled on Ethernet and Fibre Channel interfaces.
Command
Modes FCoE MAP
Command
History
Version 9.6(0.0) Supported on the FN 2210S Aggregator.
Version 9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE
Switch with the FC Flex IO module.
Usage
Information
FIP keepalive (FKA) messaging is used to detect if other FCoE devices are reachable.
To remove FIP keepalive monitoring from an FCoE map, enter the no keepalive
command.
Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the
communication between servers and a SAN fabric.
show fcoe-map — displays the Fibre Channel and FCoE configuration parameters in
FCoE maps.
show fcoe-map
Display the Fibre Channel and FCoE configuration parameters in FCoE maps.
Syntax show fcoe-map [brief | map-name]
Parameters
brief Displays an overview of currently configured FCoE maps.
map-name Displays the FC and FCoE configuration parameters in a
specified FCoE map. The FCoE map is applied on Ethernet
(FCoE) and FC ports to transmit FC storage traffic to a
specified fabric.
Command
Modes
• EXEC
• EXEC Privilege
386