Dell PowerEdge FX2/FX2s - Manual (Page 148)

show interfaces
Displays information on a specific physical interface or virtual interface.
Syntax show interfaces interface
Parameters
interface Enter one of the following keywords and slot/port or number
information:
• For the management interface on the stack-unit, enter
the keyword managementethernet followed by slot/
port information. The slot and port range is 0.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan followed
by a number from 1 to 4094.
• For a Port Channel interface, enter the keyword port-
channel followed by a number. The range is from 1 to
128.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
Use this show interfaces command for details on a specific interface. Use the
show interfaces stack-unit command for details on all interfaces on the
designated stack unit.
On the I/O Aggregator, the show interface output displays incorrect rate
information details over time for link monitoring when the rate-interval is
configured for 5 seconds. Dell Networking recommends using higher rate-intervals
such as 15 to 299 seconds to minimize the errors seen.
NOTE: In the CLI output, the power value will be rounded to a 3-digit value.
For receive/transmit power that is less than 0.000, an snmp query will return
the corresponding dbm value even though the CLI displays as 0.000.
NOTE: After the counters are cleared, the line-rate continues to increase until
it reaches the maximum line rate. When the maximum line rate is reached,
there will be no change in the line-rate.
User
Information
The following describes the show interfaces command shown in the 10G
example below.
Line Description
TenGigabitEthern
et 0/0... Displays the interface’s type, slot/port, and administrative
and line protocol status.
148