Dell PowerEdge FX2/FX2s - Manual (Page 142)

Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information The delta column displays changes since the last screen refresh.
The following are the monitor command menu options.
Key Description
systest-3 Displays the host name assigned to the system.
monitor time Displays the amount of time since the monitor
interface command was entered.
time Displays the amount of time the chassis is up (since last
reboot).
m Change the view from a single interface to all interfaces on
the stack unit or visa-versa.
c Refresh the view.
b Change the counters displayed from Packets on the
interface to Bytes.
r Change the [delta] column from change in the number of
packets/bytes in the last interval to rate per second.
l Change the view to the next interface on the stack unit, or if
in the stack unit mode, the next stack unit in the chassis.
a Change the view to the previous interface on the stack unit,
or if in line stack unit mode, the previous stack unit in the
chassis.
T Increase the screen refresh rate.
t Decrease the screen refresh rate.
q Return to the CLI prompt.
Example (Single
Interface)
systest-3 Monitor time: 00:00:06 Refresh Intvl.: 2s Time:
03:26:26
Interface: tengig 0/3, Enabled, Link is Up, Linespeed is 1000
Mbit
Traffic statistics: Current Rate Delta
Input bytes: 9069828 43 Bps 86
Output bytes: 606915800 43 Bps 86
Input packets: 54001 0 pps 1
Output packets: 9401589 0 pps 1
64B packets: 67 0 pps 0
Over 64B packets: 49166 0 pps 1
Over 127B packets: 350 0 pps 0
Over 255B packets: 1351 0 pps 0
Over 511B packets: 286 0 pps 0
142