Downstream disable links – Dell PowerEdge FX2/FX2s User Manual
Page 450
Command
Modes
UPLINK-STATE-GROUP
Command
History
Version 9.4(0.0)
Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Related
Commands
•
— assigns a port or port-channel to the uplink-state group as a
downstream interface.
•
— creates an uplink-state group and enables the tracking of
upstream links.
downstream disable links
Configure the number of downstream links in the uplink-state group that are disabled if one upstream
link in an uplink-state group goes down.
Syntax
downstream disable links {number | all}
To revert to the default setting, use the no downstream disable links
command.
Parameters
number
Enter the number of downstream links to be brought down
by UFD. The range is from 1 to 1024.
all
Brings down all downstream links in the group.
Defaults
No downstream links are disabled when an upstream link in an uplink-state group
goes down.
Command
Modes
UPLINK-STATE-GROUP
Command
History
Version 9.4(0.0)
Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information
A user-configurable number of downstream interfaces in an uplink-state group are
put into a link-down state with an UFD-Disabled error message when one
upstream interface in an uplink-state group goes down.
If all upstream interfaces in an uplink-state group go down, all downstream
interfaces in the same uplink-state group are put into a link-down state.
Related
Commands
•
— assigns a port or port-channel to the uplink-state group as a
downstream interface.
•
— creates an uplink-state group and enables the tracking of
upstream links.
450