Dell PowerEdge FX2/FX2s - Manual (Page 451)

show running-config uplink-state-group
Display the current configuration of one or more uplink-state groups.
Syntax show running-config uplink-state-group [group-id]
Parameters
group-id Displays the current configuration of all uplink-state groups
or a specified group. The valid group-id values are from 1 to
16.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Example
Dell#show running-config uplink-state-group
!
no enable
uplink state track 1
downstream TengigabitEthernet 0/2,4,6,11
upstream TengigabitEthernet 0/8, 12
upstream PortChannel 1
!
uplink state track 2
downstream TengigabitEthernet 0/1,3,5
upstream TengigabitEthernet 0/9,10
Related
Commands
• show uplink-state-group — displays the status information on a specified
uplink-state group or all groups.
• uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
show uplink-state-group
Display status information on a specified uplink-state group or all groups.
Syntax show uplink-state-group [group-id] [detail]
Parameters
group-id Displays status information on a specified uplink-state group
or all groups. The valid group-id values are from 1 to 16.
detail Displays additional status information on the upstream and
downstream interfaces in each group
Defaults none
451