Dell PowerEdge FX2/FX2s - Manual (Page 336)

ftp: After entering the keyword ftp:, you can either follow it
with the location of the source file in this form: //
userid:password@hostip/filepath or press Enter to
launch a prompt sequence.
tftp: After entering the keyword tftp:, you can either follow it
with the location of the source file in this form: //
hostlocation/filepath or press Enter to launch a
prompt sequence.
flash: After entering the keyword flash:, you can either follow it
with the location of the source file in this form: //filepath
or press Enter to launch a prompt sequence.
usbflash: After entering the keyword usbflash:, you can either
follow it with the location of the source file in this form: //
filepath or press Enter to launch a prompt sequence.
A: Enter this keyword to upgrade the bootflash partition A.
B: Enter this keyword to upgrade the bootflash partition B.
Defaults none
Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
You must reload the Dell Networking OS after executing this command.
Example
Dell#upgrade boot ?
all Upgrade both boot flash image and selector
image
bootflash-image Upgrade boot flash image
bootselector-image Upgrade boot selector image
Dell#
upgrade system
Upgrade the bootflash image or system image.
Syntax upgrade system {flash: | ftp: | scp: | tftp: | usbflash: |
stack-unit {0-5 | all} {A: | B:}
Parameters
0–5 Enter the keyword 0–5 to upgrade only the mentioned
stack-unit.
all Enter the keyword all to upgrade all the member units of
the stack.
ftp After entering the keyword ftp you can either follow it with
the location of the source file in this form://
336