Dell PowerEdge FX2/FX2s - Manual (Page 205)

Example
Dell#show monitor session 5
SessionID Source Destination Direction Mode Type
--------- ------ ----------- --------- ---- ----
5 Te 0/4 Te 0/3 rx interface Port-based
Dell#
Related
Commands monitor session — creates a session for monitoring.
show running-config monitor session
Displays the running configuration of all monitor sessions or a specific session.
Syntax show running-config monitor session {session-ID}
To display the running configuration for all monitor sessions, use the show
running-config monitor session command.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The range
is from 0 to 65535.
Defaults none
Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information The monitoring command is saved in the running configuration at the Monitor
Session mode level and can be restored after a chassis reload.
Example
Dell#show run monitor session
!
monitor session 5
source TenGigabitEthernet 0/4 destination TenGigabitEthernet
0/5 direction rx
!
monitor session 20
source TenGigabitEthernet 0/3 destination TenGigabitEthernet
0/2 direction both
Dell#
Dell#show run monitor session 20
!
monitor session 20
source TenGigabitEthernet 0/3 destination TenGigabitEthernet
0/2 direction both
Dell#
Related
Commands
monitor session — creates a session for monitoring.
205